Config Ipif - Extreme Networks EAS 200-24p Switch CLI Manual

Chapter 11: Basic Commands Command List

config ipif

Description
This command is used to configure the IP interface.
Format
config ipif <ipif_name 12> [{ipaddress <network_address> | vlan <vlan_name 32>
| proxy_arp [enable | disable] {local [enable | disable]} | state [enable |
disable]} | bootp | dhcp |ipv6 [ipv6address <ipv6networkaddr> | state [enable
| disable]] | ipv4 state [enable | disable]]
Parameters
ipif - Specifies the name of the IP interface.
●
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12 characters
●
long.
ipaddress - Configures a network on an ipif. The address should specify a host address and length
●
of network mask. Since an ipif can have only one IPv4 address, the new configured address will
overwrite the original one.
<network_address> - Enter the network address used here.
●
vlan - Specifies the name of the VLAN here.
●
<vlan_name 32> - Enter the VLAN name used here. This name can be up to 32 characters long.
●
proxy_arp - Enable/disable of proxy ARP function. It is for IPv4 function. Default: Disabled.
●
enable - Specifies that the proxy ARP option will be enabled.
●
disable - Specifies that the proxy ARP option will be disabled.
●
local - This setting controls whether the system provides the proxy reply for the ARP packets
●
destined for IP address located in the same interface as the received interface. When proxy ARP is
enabled for an interface, the system will do the proxy reply for the ARP packets destined for IP
address located in a different interface. For ARP packets destined for IP address located in the same
interface, the system will check this setting to determine whether to reply.
enable - Specifies that the local option will be enabled.
●
disable - Specifies that the local option will be disabled.
●
bootp - Use BOOTP to obtain the IPv4 address.
●
dhcp - Use DHCP to obtain the IPv4 address.
●
ipv6 - Specifies that the IPv6 configuration will be done.
●
ipv6address - Specifies the IPv6 network address. The address should specify a host address and
●
length of network prefix. There can be multiple V6 addresses defined on an interface. Thus, as a
new address is defined, it is added on this ipif.
- <ipv6networkaddr> - Enter the IPv6 address used here.
state - Specifies that the IPv6 interface state will be set to enabled or disabled.
●
enable - Specifies that the IPv6 interface sate will be enabled.
●
disable - Specifies that the IPv6 interface sate will be disabled.
●
ipv4 - Specifies that the IPv4 configuration will be done.
●
230
Extreme Networks EAS 200-24p Switch CLI Manual