Download - Extreme Networks EAS 200-24p Switch CLI Manual

Chapter 59: TFTP Client Command List

download

Description
This command is used to download the firmware image and configuration from TFTP server.
Format
download [firmware_fromTFTP [<ipaddr> | <ipv6addr>] src_file <path_filename
64> {dest_file <pathname 64>} | cfg_fromTFTP [<ipaddr> | <ipv6addr>] src_file
<path_filename 64> {dest_file <pathname 64>}]
Parameters
firmware_fromTFTP – Specifies to download firmware from a TFTP server.
●
<ipaddr> - (Optional) The IP address of the TFTP server.
●
<ipv6addr> - (Optional) The IPv6 address of the TFTP server.
●
src_file - (Optional) Used to identify the parameter "path_filename".
●
<path_filename 64> - Enter the source file path name here. This name can be up to 64 characters
●
long.
dest_file - (Optional) Used to identify the parameter "path_filename".
●
<pathname 64> - Enter the destination file path name here. This name can be up to 64 characters
●
long.
cfg_fromTFTP – Specifies to download a configuration file from a TFTP server.
●
<ipaddr> - (Optional) The IP address of the TFTP server.
●
<ipv6addr> - (Optional) The IPv6 address of the TFTP server.
●
src_file - (Optional) Used to identify the parameter "path_filename".
●
<path_filename 64> - The pathname specifies the pathname on the TFTP server. It can be a
●
relative pathname or an absolute pathname. This name can be up to 64 characters long.
dest_file - (Optional) Used to identify the parameter "path_filename".
●
<pathname 64> - The pathname specifies an absolute pathname on the device file system. If
●
pathname is not specified, it refers to the boot_up configuration file. This name can be up to 64
characters long.
Restrictions
Only Administrator-level users can issue this command.
810
Extreme Networks EAS 200-24p Switch CLI Manual