Show Wac Auth_State - Extreme Networks EAS 200-24p Switch CLI Manual

Chapter 68: Web-Based Access Control (WAC) Command List

show wac auth_state

Description
Used to display the authentication state of a port.
Format
show wac auth_state ports {<portlist>}
Parameters
ports - Specifies a range of member ports to show the status.
●
<portlist> - (Optional) Enter a list of ports to display here.
●
Restrictions
None.
Example
Supposed that port 1 is in host-based mode:
1 MAC 00-00-00-00-00-01 is authenticated without VLAN assigned (may be the specified target VLAN
does not exist or target VLAN has not been specified at all), the ID of RX VLAN will be displayed
(RX VLAN ID is 20 and the assigned VLAN ID is 4004 in this example).
2 MAC 00-00-00-00-00-02 is authenticated with target VLAN assigned, the ID of target VLAN will be
displayed (RX VLAN ID is 20 and the assigned VLAN ID is 1234 in this example).
3 MAC 00-00-00-00-00-03 failed to pass authentication, the VID field will be shown as "-" indicating
that packets with SA 00-00-00-00-00-03 will be dropped no matter which VLAN these packets are
from.
4 MAC 00-00-00-00-00-04 attempts to start authentication, the VID field will be shown as "-"until
authentication completed.
Supposed that ports 2 and 3 are in port-based mode:
1 MAC 00-00-00-00-00-10 is the MAC which made port 2 pass authentication; MAC address is
followed by "(P)" to indicate the port-based mode authentication. Supposed that port 3 is in port-
based mode:
2 MAC 00-00-00-00-00-20 attempts to start authentication, MAC address is followed by "(P)" to
indicate the port-based mode authentication.
890
Extreme Networks EAS 200-24p Switch CLI Manual