Config Dhcp_Local_Relay - Extreme Networks EAS 200-24p Switch CLI Manual

Chapter 20: DHCP Local Relay Command List

config dhcp_local_relay

Description
This command is used to enable or disable DHCP local relay function for specified VLAN name.
When DHCP local relay is enabled for the VLAN, the DHCP packet will be relayed in broadcast way
without change of the source MAC address and gateway address. DHCP option 82 will be
automatically added.
Format
config dhcp_local_relay vlan <vlan_name 32> state [enable | disable]
Parameters
vlan - Specifies the VLAN name that the DHCP local relay function will be enabled.
●
<vlan_name 32> - Enter the name of the VLAN here. This name can be up to 32 characters long.
●
state - Enable or disable DHCP local relay for specified vlan.
●
enable - Specifies that the DHCP local relay function will be enabled.
●
disable - Specifies that the DHCP local relay function will be disabled.
●
Restrictions
Only Administrator-level users can issue this command.
Example
To enable DHCP local relay for default VLAN:
EAS 200-24p:admin# config dhcp_local_relay vlan default state enable
Command: config dhcp_local_relay vlan default state enable
Success.
EAS 200-24p:admin#
332
Extreme Networks EAS 200-24p Switch CLI Manual