Extreme Networks EAS 200-24p Switch CLI Manual page 157

matching packets are counted. If the rule is bound with the flow_meter, then the "counter" is
overridden.
enable - Specifies that the ACL counter feature will be enabled.
●
disable - Specifies that the ACL counter feature will be disabled.
●
deny - Specifies that packets matching the access rule are filtered by the switch.
●
mirror - Specifies that packets matching the access rules are copied to the mirror port.
●
time_range - (Optional) Specifies the name of the time range entry.
●
<range_name 32> - Enter the time range name here. This name can be up to 32 characters long.
●
delete - Specifies that a profile or a rule will be deleted.
●
access_id - Specifies the index of the access list entry. The value range is 1-256, but the supported
●
maximum number of entries depends on the project. If the auto_assign option is selected, the access
ID is automatically assigned, when adding multiple ports.
<value 1-256> - Enter the access ID used here. This value must be between 1 and 256.
●
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure a rule entry for a packet content mask profile (option 3):
EAS 200-24p:admin#
packet_content offset5 0xF0 port all deny
Command: config access_profile profile_id 5 add access_id auto_assign
packet_content offset5 0xF0 port all deny
Success.
EAS 200-24p:admin#
Extreme Networks EAS 200-24p Switch CLI Manual
config access_profile profile_id 5 add access_id auto_assign
config access_profile
157