Config Loopdetect Ports - Extreme Networks EAS 200-24p Switch CLI Manual

Chapter 31: Loop Back Detection (LBD) Command List

config loopdetect ports

Description
This command is used to setup the loop-back detection function for the interfaces on the switch.
Format
config loopdetect ports [<portlist> | all] state [enable | disable]
Parameters
ports - Specify the range of ports that LBD will be configured on.
●
<portlist> - Enter a list of ports
●
all - To set all ports in the system, you may use the "all" parameter.
●
state - Specify whether the LBD function should be enabled or disabled on the ports specified in the
●
port list. The default state is disabled.
enable - Specify to enable the LBD function.
●
disable - Specify to disable the LBD function.
●
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the LBD function on ports 1-5:
EAS 200-24p:admin#
Command: config loopdetect ports 1-5 state enable
Success.
EAS 200-24p:admin#
496
config loopdetect ports 1-5 state enable
Extreme Networks EAS 200-24p Switch CLI Manual