Using The Remote Administration Utility; Using Out-Of-Band Management; Enabling The Telnet Service In Instant Internet - Nortel BayStack 100-S Reference

Chapter 1

Using the Remote Administration utility

This chapter explains how use Instant Internet's remote administration utility to
set up, view, or modify the unit configuration. There are two ways to use remote
administration: out-of-band management and Telnet.

Using out-of-band management

Out-of-band management is only available on the Instant Internet 100-S and
400-S units. Out-of-band management provides an easy method to set up, view, or
modify a unit's configuration either locally or remotely. Among many other
suggestions for use, this utility makes it easy for a company with multiple sites but
only one system administrator to set up each site without requiring that the system
administrator to travel to the site.
Using the Instant Internet Aux port, you can connect a PC directly to the Instant
Internet or you can connect a modem to the Instant Internet and dial into that
modem for out-of-band management. For detailed instructions on connecting to
the Aux port and setting up out-of-band management, refer to Setting Up the
BayStack Instant Internet 100-S Unit, or Setting Up the BayStack Instant Internet
400-S Unit. For information on entering the password, see
password" on page
commands" on page

Enabling the Telnet service in Instant Internet

This section explains how to enable the Telnet service in Instant Internet, and how
to access and use the remote host.
Reference for the BayStack Instant Internet Remote Access Commands Version 7.11
23. For information on entering commands, see
24.
"Providing the
"Entering
21