Routing Cables In The Cable Trough; Installing Base Station Modules - Nortel Meridian Companion Installation And Maintenance Manual

Routing cables in the cable trough

Installing Base Station Modules

P0725810 Issue 3.0
The cable trough beneath the Line Module holds the 25-pair cables,
the fiber cables, the power cords, and the power bars. The cable
trough has been designed to keep the power cords and power bars
separate from the 25-pair cables and fiber cables, and to allow easy
access after the installation.
Place the cabling in the two shelves as described in the following
chart:
In the upper shelf:
In the lower shelf:
The Base Station Module does not have plug-in cartridges.
Do not connect the fiber cable until the Controller, Line Module or
Modules and Base Station Module or Modules are all installed, and
the wiring is complete (see "Connecting the fiber cables").
When installing a Controller, Line Modules, and Base Station
Modules in a row, install all the mounting brackets before installing
the equipment (see step 1). This will ensure optimum use of wall
space.
COMPANION 200 Installation and Maintenance Guide
Installing the hardware 44
Place the 25-pair cables in the back and the
fiber cables in the front. This shelf is for all 25-
pair cables and fiber cables only.
Place all power cords and power bars only.