Related
Documentation
Installing the MX2020 Extended EMI Cover
Copyright © 2015, Juniper Networks, Inc.
Figure 156: Installing the Standard EMI Card Cage Cover
0
10
11
12
13
14
15
16
17
18
Removing the MX2020 Standard EMI Covers on page 465
Two extended electromagnetic interference (EMI) covers attach to the router over the
upper and lower card cages.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
On each side of the upper and lower card cage, orient the extended EMI cover mounting
2.
brackets so that they line up with the mounting holes.
For the upper extended EMI card cover, the groove that holds the points on the cover
should be at the top.
For the lower extended EMI card cover, the groove that holds the points on the cover
should be at the bottom.
Secure the extended EMI cover mounting brackets using the four screws provided
3.
(two on each side) (see
Chapter 22: Installing and Replacing Components
Figure 157 on page
310).
309