Installing A T320 Standard Control Board Or T-Cb; Figure 83: Removing A T320 Standard Control Board - Juniper Core Router T Series Hardware Manual

See Also
Copyright © 2018, Juniper Networks, Inc.
Place one hand underneath the control board to support it and slide it completely out
7.
of the chassis.
Place the control board on the antistatic mat.
8.
If you are not replacing the control board now, install a blank panel over the empty
9.
slot.

Figure 83: Removing a T320 Standard Control Board

Preventing Electrostatic Discharge Damage to a T320 Router on page 330
T320 Control Board Description on page 30
T320 Standard Control Board Description on page 31
T320 T Series Control Board (T-CB) Description on page 31
T320 Standard Control Board and T-CB LEDs on page 32
Maintaining the T320 Control Boards on page 277

Installing a T320 Standard Control Board or T-CB

To install a standard control board or T-CB (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Carefully align the sides of the control board with the guides inside the chassis.
2.
Slide the control board into the chassis, carefully ensuring that it is correctly aligned.
3.
Grasp both ejector handles, and press them inward to seat the control board.
4.
Tighten the captive screws on the ejector handles, using a Phillips (+) screwdriver,
5.
number 2.
Chapter 26: Replacing Host Subsystem Components
Figure 84 on page 210):
209