Installing A Ptx5000 Craft Interface; Figure 142: Removing The Craft Interface; Figure 143: Installing A Replacement Craft Interface - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide

Installing a PTX5000 Craft Interface

Related
Documentation
264

Figure 142: Removing the Craft Interface

To install the craft interface (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Locate the ribbon cable on the left side.
2.
Squeeze the latches on either side of the ribbon cable connector where it attaches to
3.
the rear of the craft interface, and connect the cable.
Grasp the craft interface, and press it into the chassis.
4.
Tighten the screws at the four corners of the craft interface, using a number 2 Phillips
5.
(+) screwdriver.
NOTE: After you install the craft interface in an operating packet transport
router, allow several minutes for the LEDs on the craft interface to reflect the
current state of the packet transport router.

Figure 143: Installing a Replacement Craft Interface

PTX5000 Craft Interface Description on page 16
Prevention of Electrostatic Discharge Damage on page 611
Figure 143 on page 264):
Copyright © 2017, Juniper Networks, Inc.