Installing The Mx240 Craft Interface; Figure 100: Removing The Craft Interface - Juniper MX240 Hardware Manual

MX240 5G Universal Routing Platform Hardware Guide
See Also
252
Grasp the craft interface faceplate and carefully tilt it toward you until it is horizontal.
4.
Disconnect the ribbon cable from the back of the faceplate by gently pressing on both
5.
sides of the latch with your thumb and forefinger. Remove the craft interface from
the chassis.

Figure 100: Removing the Craft Interface

MX240 Craft Interface Overview on page 35
Preventing Electrostatic Discharge Damage to an MX240 Router on page 380

Installing the MX240 Craft Interface

To install the craft interface (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Grasp the craft interface with one hand, and hold the bottom edge of the craft interface
2.
with the other hand to support its weight.
Orient the ribbon cable so that it plugs into the connector socket. The connector is
3.
keyed and can be inserted only one way.
Align the bottom of the craft interface with the sheet metal above the card cage and
4.
press it into place.
Tighten the screws on the left and right corners of the craft interface faceplate.
5.
Reattach any external devices connected to the craft interface.
6.
Figure 101 on page 253):
Copyright © 2019, Juniper Networks, Inc.