Installing An Sfp Or Xfp Transceiver Into An Mx240 Dpc, Mpc, Mic, Or Pic - Juniper MX240 Hardware Manual

Related
Documentation

Installing an SFP or XFP Transceiver into an MX240 DPC, MPC, MIC, or PIC

Copyright © 2017, Juniper Networks, Inc.
For more information about the command, see the
To bring a PIC online:
Press the PIC offline/online button until the PIC LED lights green. For a PIC installed
in FPC3, use a narrow-ended tool that fits inside the opening that leads to the
button.
Issue the following CLI command:
user@host>request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see the
To bring a MIC online:
Press the MIC offline/online button until the PIC LED lights green.
Issue the following CLI command:
user@host>request chassis mic fpc-slot mpc-slot pic-slot mic-slot online
For more information about the command, see the
The normal functioning indicator LED confirms that the component is online. You can
also verify correct DPC or MPC functioning by issuing the
or correct MIC or PIC functioning by issuing the
Preventing Electrostatic Discharge Damage to an MX240 Router on page 444
Removing a Cable on an MX240 DPC, MPC, MIC, or PIC on page 320
Maintaining MX240 DPCs on page 382
Maintaining MX240 MPCs on page 393
Maintaining MX240 MICs on page 393
Maintaining MX240 PICs on page 395
To install an SFP or XFP:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Take each transceiver to be installed out of its electrostatic bag, and identify the slot
2.
on the component where it will be installed.
Verify that each transceiver is covered by a rubber safety cap. If it is not, cover the
3.
transceiver with a safety cap.
Chapter 21: Installing Components
.
CLI Explorer
.
CLI Explorer
CLI Explorer .
show chassis fpc
show chassis fpc pic-status
command
.
255