M120 Multiservice Edge Router Hardware Guide
See Also
Installing an SFP or XFP Transceiver
236
Figure 94: Removing M120 SFPs or XFPs
Place a rubber safety cap over the transceiver.
9.
Place the removed transceiver on an antistatic mat or in an electrostatic bag.
10.
CAUTION:
After removing a transceiver from the chassis, wait at least 30
seconds before reinserting it or inserting a transceiver into a different slot.
M120 Router Chassis Description on page 7
Overview of Troubleshooting Resources for the M120 Router on page 283
Installing an SFP or XFP Transceiver on page 236
To install an SFP or XFP (see
Attach an ESD wrist strap to your bare wrist and connect the wrist strap to one of the
1.
ESD points on the chassis.
Take each transceiver to be installed out of its electrostatic bag and identify the slot
2.
on the PIC or CFPC where it will be installed.
Verify that each transceiver is covered by a rubber safety cap. If it is not, cover the
3.
transceiver with a safety cap.
Carefully align the transceiver with the slots in the PIC or CFPC. The connectors should
4.
face the PIC or CFPC.
"Removing SFPs or XFPs" on page
Copyright © 2018, Juniper Networks, Inc.
236):