MX960 3D Universal Edge Router Hardware Guide
Related
Documentation
Installing an SFP or XFP Transceiver into an MX960 DPC, MPC, MIC, or PIC
304
Figure 110: Installing an SCB
Preventing Electrostatic Discharge Damage to an MX960 Router
Operating and Positioning the MX960 SCB Ejectors
Removing an MX960 SCB on page 410
To install an SFP or XFP:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Take each transceiver to be installed out of its electrostatic bag, and identify the slot
2.
on the component where it will be installed.
Verify that each transceiver is covered by a rubber safety cap. If it is not, cover the
3.
transceiver with a safety cap.
Copyright © 2017, Juniper Networks, Inc.