Installing The Open-Frame Rack Mounting Shelf - Juniper PTX5000 Hardware Manual

Installing the Open-Frame Rack Mounting Shelf

Copyright © 2017, Juniper Networks, Inc.
Table 78: Mounting Hole Locations for Installing a Chassis in an
Open-Frame Rack (continued)
Hole Distance Above U Division
23 13.13 in. (33.3 cm)
Before mounting the chassis in an open-frame rack, you must first install the open-frame
rack mounting shelf.
To install the open-frame rack mounting shelf (see
On the rear of each rack rail, partially insert a mounting screw into the highest hole
1.
specified in Table 77 on page 170
Install the open-frame rack mounting shelf on the rack. Hang the shelf over the
2.
mounting screws by using the keyhole slots located near the top of the shelf flanges.
Partially insert screws into the open holes in the flanges of the open-frame rack
3.
mounting shelf.
Tighten all the screws completely.
4.
Chapter 16: Installing the Mounting Hardware
7.50 U
Figure 81 on page
for the open-frame rack mounting shelf.
172):
171