Table 74: Accessory Box Parts List - Juniper PTX5000 Hardware Manual

Table 73: Packet Transport Router Parts List (continued)
Component
Open-frame mounting shelf
Four-post mounting shelf
Rear support bracket—Required only for mounting a four-post rack or
cabinet
Blank panels for slots without components installed
Copyright © 2017, Juniper Networks, Inc.

Table 74: Accessory Box Parts List

Part
Screws to mount chassis, Phillips, 12-24 x 1/2 in. ,
self-tapping
Split washers for the grounding cable
Screws to fasten grounding cable to chassis, Phillips,
1/4-20 x 3/8
DC cable lugs and power cable management system
Connectors for alarm relay cables, Terminal Block
Plug, 3 Pole, 5.08 mm spacing, 12 A
End User License Agreement (EULA)
ROHS and warranty card
15-ft Ethernet cable to connect the Routing Engine to
a management device (RJ-45 connectors, 4-pair
stranded UTP, Category 5E)
7-ft serial cable to connect the Routing Engine to a
management console (DB9 to RJ-45 adapter, straight
through)
Chapter 15: Unpacking the Router
Quantity
1
1
1
One blank panel for each slot not occupied by a
component
Quantity
42
3
3
Depending on your configuration, the
following parts are included;
60-A DC PDU— 36 4-AWG cable lugs
120-A DC PDU— 20 0-AWG cable lugs
High Capacity DC PDU—72 4-AWG
cable lugs and power cable
management system
NOTE: Spare cable lugs are included in
the accessory kit. Use one of the included
spare cable lugs to connect the PTX5000
to earth ground.
3
1
1
1
1
163