Tools And Parts Required To Provide Dc Power; Pdu; Identifying The Parts Of The Cable Management System - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide

Tools and Parts Required to Provide DC Power

Related
Documentation
Installing the PTX5000 Cable Management System for High Capacity DC PDU

Identifying the Parts of the Cable Management System

196
If you have a DC-powered router, gather the tools required to connect the PTX5000 to
DC power:
7/16-in. (11-mm) nut driver, with a minimum of 81 lb-in. (9.0 Nm) tightening torque, for
tightening nuts to the terminal studs.
CAUTION: You must use an appropriate torque-controlled tool to tighten
the nuts. Applying excessive torque damages the terminal studs. The
maximum torque that may be applied to this nut is 99 lb-in. (11 Nm).
Phillips (+) screwdriver, number 2
DC power cables, which you must provide
DC power lugs
Understanding Normal-Capacity Power System Power Zones on page 71
PTX5000 AC Power System Description on page 42
PTX5000 DC Power System Description on page 33
Connecting Power to the PTX5000 60-A DC Input Power Trays on page 202
Connecting Power to the PTX5000 120-A DC Input Power Trays on page 207
Identifying the Parts of the Cable Management System on page 196
Installing the Cable Management Comb Assembly with Extension on page 197
Widening the Cable Management Comb Assembly Extension on page 200
Installing the Cable Management Comb Assembly Without Extension on page 200
NOTE: You cannot install this cable management system on a two-post rack.
Remove the cable management system parts from the accessories kit in the shipping
1.
crate.
Identify all the parts of the cable management system.
2.
Two comb panel assemblies—the comb assembly, fixed to the extension panel
with four screws, is detachable. See
of the cable manager.
Figure 93 on page 197 for left and right side views
Copyright © 2017, Juniper Networks, Inc.