Figure 113: Removing The Retaining Nut From A Three-Phase Wye Ac Power; Figure 114: Connecting The Metal Retaining Bracket To The Three-Phase Wye Ac - Juniper PTX5000 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.

Figure 113: Removing the Retaining Nut from a Three-Phase Wye AC Power

Cord
1 1
1— Retaining nut
Put the wires of the AC power cord through the hole of the metal retaining bracket,
5.
and screw the retaining nut onto the AC power cord to secure it to the metal retaining
bracket (see Figure 114 on page
Figure 114: Connecting the Metal Retaining Bracket to the Three-Phase
Wye AC Power Cord
1 1
2
1— Retaining nut
2—Metal retaining bracket
Using a number 2 Phillips (+) screwdriver, loosen the two captive screws on the metal
6.
AC wiring compartment. Open the metal door of the metal AC wiring compartment.
Push the wires of the AC power cord into the area for the metal retaining bracket, and
pull the wires to the left toward the metal AC wiring compartment. Using a number
2 Phillips (+) screwdriver, use the four captive screws on the metal retaining bracket
to secure the AC power cord to the PDU (see
Chapter 21: Connecting the Router to Power
2
2— Three-phase wye AC power cord
217).
3
3— Three-phase wye AC power cord
Figure 115 on page 218).
217