Replacing A Ptx5000 Vertical Air Filter; Removing A Ptx5000 Vertical Air Filter - Juniper PTX5000 Hardware Manual

Related
Documentation

Replacing a PTX5000 Vertical Air Filter

Removing a PTX5000 Vertical Air Filter

Copyright © 2017, Juniper Networks, Inc.
PTX5000 Cooling System Description on page 27
Prevention of Electrostatic Discharge Damage on page 611
Removing a PTX5000 Vertical Air Filter on page 273
1.
Installing a PTX5000 Vertical Air Filter on page 275
2.
The vertical air filter is located with the vertical fan tray
weighs approximately 7.6 lb (3.5 kg).
To remove the vertical air filter:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Loosen the two captive screws on the vertical air filter tray.
2.
Grasp the head of the loosened screws, and pull to remove the air filter tray (see
3.
Figure 150 on page 274).
Locate the two areas near each rear corner, where the air filter tray is exposed. Using
4.
these air filter tray frame access areas, slide the air filter toward the air filter tray
faceplate, and pull up on the air filter to release the rear edge of the air filter from the
air filter tray (see Figure 151 on page
Remove the air filter from the air filter tray.
5.
Discard the air filter.
6.
Chapter 26: Removing and Installing Cooling System Components
fan tray 0
274).
. The vertical air filter
273