Installing A Ptx5000 Three-Phase Delta Ac Pdu Power Cord; Figure 195: Removing The Metal Retaining Bracket And Ac Power Cord; Figure 196: Removing The Metal Retaining Bracket From The Ac Power Cord - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide

Installing a PTX5000 Three-Phase Delta AC PDU Power Cord

322

Figure 195: Removing the Metal Retaining Bracket and AC Power Cord

Unscrew the retaining nut from the AC power cord, and detach the AC power cord
8.
from the metal retaining bracket.
NOTE: Reserve the retaining nut to attach the metal retaining bracket to
the replacement AC power cord.
Figure 196: Removing the Metal Retaining Bracket from the AC Power
Cord
1 1
2
1— Retaining nut
2—Metal retaining bracket
To install a three-phase delta AC power cord:
Ensure that the voltage across the AC power source is 0 V and that there is no chance
1.
that the voltage might become active during installation.
Switch the circuit breaker and power
2.
3
3— Three-phase delta AC power cord
OUTPUT switch on the PDU to the off (
Copyright © 2017, Juniper Networks, Inc.
O )position.