Table 60: Ac Power Cord Specifications For The Three-Phase Ac Power - Juniper PTX5000 Hardware Manual

Table 60: AC Power Cord Specifications for the Three-Phase AC Power Cords
Power
Cord Region Model Number
Delta North CBL-PTX-AC-D
America
CBL2-PTX-100AC-D
CBL2-PTX-150AC-D
Wye Europe CBL-PTX-AC-W
CBL2-PTX-AC-W-S
Copyright © 2017, Juniper Networks, Inc.
NOTE: In North America, AC power cords must not exceed 4.5 m
(approximately 14.8 ft) in length, to comply with National Electrical Code
(NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52, and Canadian Electrical
Code (CEC) Section 4-010(3). The cords supplied with the router are in
compliance.
Each AC PDU has a metal wiring compartment that contains the AC terminal block and
ground.
The delta AC terminal block consists of three input terminals labeled
from left to right.
The wye AC terminal block consists of four input terminals labeled
from left to right.
Table 60 on page 133 provides specifications for the AC power cords.
Electrical Specification
60 A @ 250 VAC
100 A @ 250 V
150 A @ 250 A
32 A @ 400 VAC
63 A @ 400 VAC
Figure 66 on page 134 and
each region supported.
Chapter 10: AC Power Specifications and Requirements
Figure 67 on page 134 show the AC power cord provided for
L1 , L2 , and
, , , and
L1 L2 L3
Plug Type Wire
IEC60309 4 wires labeled
, , ,
GND L1 L2
and L3
IEC60309 5 wires labeled
GND , L1 , L2 , L3 ,
and N
L3 ,
,
N
Pole
3-pole
4-pole
133