Juniper PTX5000 Hardware Manual page 218

PTX5000 Packet Transport Router Hardware Guide
182
NOTE: If you plan to install the PTX5000 in an open-frame rack, you can
install the door before the chassis is mounted in the rack. However, this
procedure assumes that the packet transport has been installed in the rack
and grounded. If you install the door before grounding the router, ensure that
you use proper site grounding.
Before you begin, ensure that you have the following parts and tools available to install
the front door on a PTX5000 in an open-frame rack.
Electrostatic discharge (ESD) grounding strap
Phillips (+) screwdriver, number 2
To install the front door on a PTX5000 router in an open-frame rack (see
Figure 86 on page 183 and
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to the approved ESD site grounding point.
Using the provided UNC 12–24 screws, attach the long mounting brackets to the rear
2.
of each front-mounting flange. Insert screws only at the top and bottom of each
bracket. The top screw should be inserted at the third front-mounting flange hole
from the top of the chassis. Line up the edge of the mounting bracket with the flange
edge of the router chassis. Tighten the screws completely using the Phillips (+)
screwdriver.
Figure 87 on page 184):
Copyright © 2017, Juniper Networks, Inc.