Removing A Ptx5000 Management Ethernet Cable; Installing A Ptx5000 Management Ethernet Cable; Figure 261: Management Ethernet Cable Connector; Figure 262: Host/Ethernet Port On The Control Board - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide

Removing a PTX5000 Management Ethernet Cable

Installing a PTX5000 Management Ethernet Cable

408
To remove a management Ethernet cable:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Press the tab on the connector and pull the connector straight out of the
2.
HOST/ETHERNET port (see
connector.
Disconnect the cable from the network device.
3.

Figure 261: Management Ethernet Cable Connector

Figure 262: Host/Ethernet Port on the Control Board

1— Host/Ethernet port
To install a Management Ethernet cable:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
CAUTION: During the initial installation before the chassis is grounded,
you must connect to an approved site ESD point. See the instructions for
your site.
Plug one end of a UTP Category 5 Ethernet cable into the
2.
the Control Board . This port connects to the Routing Engine installed into the Control
Board.
Plug the other end of the cable into the network device.
3.
Figure 262 on page 408). Figure 261 on page 408
1
Copyright © 2017, Juniper Networks, Inc.
shows the
port on
HOST/ETHERNET