Juniper PTX5000 Hardware Manual page 297

Copyright © 2017, Juniper Networks, Inc.
Table 80: Tools and Parts Required for Component
Replacement (continued)
Components
Control Board
CCG
Craft interface
DC PDU
DC power cable
Fan tray
FPC
PIC
Routing Engine
Chapter 24: Overview of Removing and Installing Components
Tool or part
Phillips (+) screwdrivers, numbers 1 and 2
Electrostatic bag or antistatic mat
Blank panel (if component is not reinstalled)
Phillips (+) screwdrivers, numbers 1 and 2
Phillips (+) screwdrivers, numbers 1 and 2
Phillips (+) screwdrivers, numbers 1 and 2
7/16-in. (11-mm) nut driver
CAUTION: You must use an appropriate
torque-controlled tool to tighten the nuts.
Applying excessive torque damages the
terminal studs and the PDU input power trays.
7/16-in. (11-mm) nut driver
CAUTION: You must use an appropriate
torque-controlled tool to tighten the nuts.
Applying excessive torque damages the
terminal studs and the PDU input power trays.
Phillips (+) screwdrivers, numbers 1 and 2
Phillips (+) screwdrivers, numbers 1 and 2
Blank panel (if component is not reinstalled)
Electrostatic bag or antistatic mat
Phillips (+) screwdrivers, numbers 1 and 2
Rubber safety cap for fiber-optic PICs or
fiber-optic PIC cables
Electrostatic bag or antistatic mat
Blank panel (if component is not reinstalled)
Phillips (+) screwdrivers, numbers 1 and 2
Electrostatic bag or antistatic mat
Blank panel (if component is not reinstalled)
261