Craft Interface Lcd; Idle Mode; Figure 7: Lcd In Idle Mode - Juniper PTX5000 Hardware Manual

Craft Interface LCD

Copyright © 2017, Juniper Networks, Inc.
NOTE: The CHASSIS ID configuration switch is set to 0 by default.
LEDs
Yellow LED, Red
Minor Alarm
button
ACO/LT
Host Subsystem Master
SIB and LEDs
OK ACT
Fan tray LEDs
PDU LEDs
PSM LEDs
A four-line LCD is located in the craft interface, along with six navigation buttons. The
LCD operates in two modes:
LCD idle mode
LCD alarm mode

Idle Mode

During normal operation, the LCD operates in idle mode and reports current status
information, as shown in Figure 7 on page

Figure 7: LCD in Idle Mode

The lines in the display report the following information:
First line—Packet transport router name.
Second line—Length of time the packet transport router has been running, reported in
the following form:
Up days + hours:minutes
Third and fourth lines—Status messages, which rotate at 2-second intervals. Some
conditions, such as removal or insertion of a system component, can interrupt the
messages.
To add a message that alternates every 2 seconds with the default status messages,
use the
set chassis display message
Chapter 2: Chassis Components and Descriptions
LED, and alarm cutoff/lamp test
Major Critical Alarm
, OK , and FAIL LEDs
17.
command.
17