Removing And Replacing Sibs In A Ptx5000; Figure 284: Removing A Sib - Juniper PTX5000 Hardware Manual

Removing and Replacing SIBs in a PTX5000

Copyright © 2017, Juniper Networks, Inc.
NOTE: After powering off a power supply, you must wait at least 60
seconds before powering it on again.
To remove a SIB:
Prepare the chassis for the upgrade by issuing the
1.
command at the
default
Place an electrostatic bag or antistatic mat on a flat, stable surface.
2.
Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the
3.
ESD points on the chassis.
Take the SIB offline. Press and hold the
4.
The green LED on the faceplate turns off. Hold the button down until the LED
OK
completely turns off.
Twist the ejector handles counterclockwise to unseat the SIB.
5.
Grasp both ejector handles, pull firmly, and slide the SIB about three-quarters of the
6.
way out of the chassis.

Figure 284: Removing a SIB

Place one hand underneath the SIB to support it and slide it completely out of the
7.
chassis. Place it on the antistatic mat.
set chassis fabric upgrade-mode
hierarchy level.
[edit]
ONLINE/OFFLINE
Chapter 33: Upgrading FPCs
button on the SIB faceplate.
471