Figure 102: Connecting The Dc Source Power Cable Lugs To An Input Power Tray - Juniper PTX5000 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.
Figure 102: Connecting the DC Source Power Cable Lugs to an Input Power
Tray
Cable restraint
Tighten the cable restraint over the DC power cables.
14.
Verify that the source power cables are connected to the appropriate terminal: the
15.
positive (+) source cable to the return terminal (labeled
source cable to the input terminal (labeled
Close the input power tray cover, and secure it with the screw.
16.
Insert the input power tray into the PDU (see
17.
Repeat the procedure for all input power trays in the PDU.
18.
Repeat the procedure for the other PDU.
19.
Verify that the DC power cables do not touch or block access to the components, and
20.
that they do not drape where people could trip on them.
Chapter 21: Connecting the Router to Power
) and the negative (–)
RTN
).
–48V
Figure 103 on page 210).
209