PTX5000 Packet Transport Router Hardware Guide
High Capacity AC Power Supply Module LEDs
Table 26: High Capacity AC Power Supply Module LEDs
LED
Color
AC input
Green
OK
–
AC output
Green
OK
–
Red
Fault (
)
–
60-A and 120-A DC Power Supply Module LEDs
68
Table 26 on page 68
describes the LEDs on the High Capacity AC power supply module
faceplate.
State
On steadily
Blinking
Off
On steadily
Blinking
Off
On steadily
Off
Table 27 on page 69
describes the DC power supply module LEDs on the faceplate. The
60-A PSM and 120-A PSM have the same LEDs.
Description
PSM is receiving voltage.
PSM is receiving voltage outside the supported range. The
supported range is 180–305 V.
Input voltage is not present.
Output is functioning normally, and input voltage is within the
supported range.
PSM is not enabled or is in a fault condition, or the input voltage
to the PSM is too low.
Output is not functioning normally because of a fault condition or
the PSM is not receiving input voltage.
PSM might be starting up, not properly installed, not receiving
sufficient power, or not functioning properly.
No faults have been detected for the PSM, or the PSM is not
receiving any input voltage.
Copyright © 2017, Juniper Networks, Inc.