Installing A Ptx5000 High Capacity Single-Phase Ac Pdu; Figure 234: Installing A Single-Phase Ac Pdu - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide

Installing a PTX5000 High Capacity Single-Phase AC PDU

364
To install a Single-Phase AC PDU:
Ensure that the voltage across the AC power source is 0 V and that there is no chance
1.
that the voltage might become active during installation.
Move the power switch located on the faceplate of the PDU to the standby ( )
2.
position.
Grasping both the front and top installation handles, insert the replacement PDU into
3.
the PDU slot. See Figure 234 on page

Figure 234: Installing a Single-Phase AC PDU

Using both hands, slide the PDU into the chassis until you feel resistance.
4.
Push the front installation handle up toward the PDU. Using a number 2 Phillips (+)
5.
screwdriver, tighten the captive screws on the handle.
364.
Copyright © 2017, Juniper Networks, Inc.