Figure 242: Inserting High Capacity Psm Sleeve; Figure 243: Fixing Psm Sleeve Bracket - Juniper PTX5000 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.
To install the High Capacity AC and DC PSM sleeve assembly:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Remove the existing PSMs from the chassis. See
2.
120-A DC PSM" on page 303
Take out the PSM sleeve assembly from the upgrade kit and remove the bracket by
3.
using a number 1 Phillips (+) screwdriver.
Insert the sleeve into one of the empty PSM slots and push the sleeve in until it is flush
4.
against the side of the chassis (see

Figure 242: Inserting High Capacity PSM Sleeve

Align and fix the sleeve bracket tabs in to the slots at the top and bottom of the sleeve
5.
(see Figure 243 on page

Figure 243: Fixing PSM Sleeve Bracket

Chapter 28: Upgrading to the High Capacity Power System
"Replacing a PTX5000 60-A or
and "Replacing a PTX5000 AC PSM" on page 340
Figure 242 on page
381).
for details.
381).
381