Installing A Ptx5000 Fpc - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide

Installing a PTX5000 FPC

432
CAUTION: The FPC power connector is located in the corner where the bottom
and the connector edges meet. If a power connector prong becomes bent, it
no longer aligns with the female connector on the midplane, and the FPC no
longer functions.
To install an FPC (see Figure 274 on page 433
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Place the FPC on an antistatic mat.
2.
Take each PIC to be installed in the replacement FPC out of its electrostatic bag and
3.
identify the slot on the FPC where it will be connected.
Verify that each fiber-optic PIC has a rubber safety cap covering the PIC transceiver.
4.
If it does not, cover the transceiver with a safety cap.
Install each PIC into the appropriate slot on the FPC. For information about installing
5.
a PIC, see the installation instructions in
Locate the slot in the FPC card cage in which you plan to install the FPC.
6.
Inspect the slot in the FPC card cage to verify that there are no missing or bent pins
7.
on the midplane.
Inspect the FPC to verify that the connectors are not misaligned or damaged.
8.
Orient the FPC vertically with the component side facing to the right. Be sure the FPC
9.
is right-side up, with the components on the right of the FPC.
CAUTION: When the FPC is out of the chassis, do not hold it by the ejector
handles, bus bars, or edge connectors. They cannot support its weight.
Carefully align the connector edge of the FPC with the appropriate empty slot in the
10.
chassis.
Lift the FPC into place and carefully align the bottom and top of the FPC with the
11.
guides inside the card cage.
and Figure 275 on page
"Replacing a PTX5000 PIC" on page
Copyright © 2017, Juniper Networks, Inc.
435):
435.