Figure 37: 60-A Dc Pdu; Table 18: 60-A Dc Pdu Leds - Juniper PTX5000 Hardware Manual

Table 18: 60-A DC PDU LEDs

LED Color
—One Green
PDU OK
per power
supply
Red
–
—One per Green
DC IN
input
–
SW ON —One Green
per input power
tray
–
Copyright © 2017, Juniper Networks, Inc.

Figure 37: 60-A DC PDU

PDU
PDU OK
SW0 ON SW1 ON SW2 ON SW3 ON
1— PDU OK LED
2— SW ON
LEDs
Table 18 on page 57 describes the LEDs on the 60-A DC PDU faceplate.
State
On steadily
On steadily
Off
On steadily
Off
On steadily
Off
Chapter 4: Power System Components and Descriptions
1 1
2
3
3— DC IN LEDs
Description
PDU is functioning normally.
PDU has failed.
PDU might be starting up or not receiving any input voltage.
Input is receiving voltage.
Input voltage is not present, or is under –40 V.
The input power switch is powered on.
The LED might be off for one of the following reasons:
The input power switches might be off or the host subsystem
detected a failure and turned off the input power switch.
The input power switch is on but at least one input is under
–40 V.
The input is not receiving any voltage.
57