Figure 252: Installing An Ssd Drive In A Re-Duo-C2600-16G - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide
Copying the Junos OS to the Solid-State Disk in a PTX5000 Routing Engine
Related
Documentation
398

Figure 252: Installing an SSD Drive in a RE-DUO-C2600-16G

After installing a solid-state disk (SSD) for the first time, you must copy the software
from the Routing Engine's CompactFlash card to the SSD drive.
To copy software to the SSD drive:
On the console or other management device connected to the Routing Engine, enter
1.
CLI operational mode.
Partition the SSD drive. Issue the
2.
Wait until a message appears on the console confirming that the partition procedure
3.
is complete.
Reboot the router's software. Issue the
4.
Back up the currently running and active file system partitions on the router to standby
5.
partitions that are not running. Issue the
request system snapshot
Wait until a message appears on the console confirming that the snapshot procedure
6.
is complete.
Reboot the router's software again. Issue the
7.
Verify that the SSD drive is listed as the secondary boot device. The output lists the
8.
devices mounted. The SSD drive is located at
command.
PTX5000 Routing Engine Description on page 76
PTX5000 Routing Engine LEDs on page 80
Troubleshooting the PTX5000 Routing Engines on page 522
Prevention of Electrostatic Discharge Damage on page 611
request system partition hard-disk
request system reboot
request system snapshot
command.
request system reboot
. issue the
ad1
command.
command.
command.issue the
command.
show system boot-messages
Copyright © 2017, Juniper Networks, Inc.