Figure 285: Installing A Sib - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide
472
CAUTION: Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.
To install the new SIBs:

Figure 285: Installing a SIB

Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the
1.
ESD points on the chassis.
Press and hold the ONLINE/OFFLINE
2.
on the faceplate turns off. Hold the button down until the LED completely turns off.
Place one hand underneath the SIB to support it. With the other hand, hold one of the
3.
ejector handles on the SIB faceplate.
Carefully align the sides of the SIB with the guides inside the chassis.
4.
Slide the SIB into the chassis, carefully ensuring that it is correctly aligned.
5.
Twist the ejector handles clockwise until they stop.
6.
Install all the SIBs one by one.
7.
button on the SIB faceplate. The green
Copyright © 2017, Juniper Networks, Inc.
OK LED