Installing The Mounting Hardware; Installing The Ptx5000 Mounting Hardware For A Four-Post Rack Or Cabinet; Installing Cage Nuts, If Needed; Table 75: Mounting Hole Locations For Installing The Four-Post Mounting Shelf And Rear Support Bracket - Juniper PTX5000 Hardware Manual

CHAPTER 16

Installing the Mounting Hardware

Installing the PTX5000 Mounting Hardware for a Four-Post Rack or Cabinet

Installing Cage Nuts, If Needed

Copyright © 2017, Juniper Networks, Inc.
Installing the PTX5000 Mounting Hardware for a Four-Post Rack or Cabinet on page 165
Installing the PTX5000 Mounting Hardware for an Open-Frame Rack on page 169
Installing Cage Nuts, If Needed on page 165
1.
Installing the Four-Post Mounting Shelf and Rear Support Bracket on page 167
2.
Removing the Center-Mounting Brackets on page 168
3.
Insert cage nuts, if needed, into the holes listed in
Table 76 on page 166 (an X indicates a mounting hole location). The hole distances are
relative to the standard U division on the rack that is aligned with the bottom of the
mounting shelf and rear support bracket.
To install cage nuts in a four-post rack:
On the rear rack rails, insert cage nuts in the holes specified for the rear support bracket.
1.
Install the cage nuts in the rear of the rear rail (see
On the front rack rails, insert cage nuts in the holes specified for the four-post mounting
2.
shelf. Install the cage nuts in the front of the front rail (see
On the front rack rails, insert cage nuts in the holes specified for mounting the chassis.
3.
Install the cage nuts in the front of the front rail (see
Table 75: Mounting Hole Locations for Installing the Four-Post Mounting
Shelf and Rear Support Bracket
Hole Distance Above U Division
6 3.25 in. (8.3 cm)
5 2.63 in. (6.7 cm)
Table 75 on page 165
Table 75 on page
Table 75 on page
Table 76 on page
Four-Post Rack
Mounting Shelf
1.86 U X
1.5 U X
and
165).
165).
166).
Rear
Support
Bracket
X
X
165