Installing A Ptx5000 High Capacity Delta Ac Pdu; Figure 219: Removing A High Capacity Delta Ac Pdu - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide

Installing a PTX5000 High Capacity Delta AC PDU

346

Figure 219: Removing a High Capacity Delta AC PDU

Use the captive screws on the metal retaining bracket to reattach it to the PDU being
13.
removed.
WARNING: Do not touch the power connectors on the rear of the PDU. They
can contain dangerous voltages.
CAUTION: Do not leave a PDU slot empty for more than a short time while
the packet transport router is operational. For proper airflow, the PDU must
remain in the chassis or a blank panel must be used in an empty slot.
To install a High Capacity Delta AC PDU:
Ensure that the voltage across the AC power source is 0 V and that there is no chance
1.
that the voltage might become active during installation.
Move the power switch located on the faceplate of the PDU to the standby ( )
2.
position.
Grasp the front installation handle and top installation handle, and insert the PDU
3.
into the PDU slot. See Figure 220 on page 347.
Copyright © 2017, Juniper Networks, Inc.