Alarm And Management Cable Specifications And Pinouts; Table 72: Rj-45 Connector Pinouts - Juniper PTX5000 Hardware Manual

Table 71: RJ-45 Connector Pinouts for the PTX5000 Auxiliary and Console Ports (continued)
Pin Signal
8 CTS Input
Related
Documentation
RJ-45 Connector Pinouts for the PTX5000 Management HOST/ETHERNET Port
Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
PTX5000 Control Board Description on page 83
Connecting the PTX5000 Packet Transport Router to a Management Console or
Auxiliary Device on page 188
The management Ethernet port on the Control Board labeled
autosensing 10/100-Mbps/1-Gbps Ethernet RJ-45 receptacle that accepts an Ethernet
cable for connecting the Routing Engine to a management LAN (or other device that
supports out-of-band management).
pinouts.

Table 72: RJ-45 Connector Pinouts

Pin Signal
1 TX+
2 TX –
3 RX+
4 Termination network
5 Termination network
6 RX–
7 Termination network
8 Termination network
PTX5000 Control Board Description on page 83
Connecting the PTX5000 Packet Transport Router to a Management Ethernet Device
on page 189
Chapter 13: Alarm and Management Cable Specifications and Pinouts
Description
Clear to send
Table 72 on page 151
is an
HOST/ETHERNET
describes the RJ-45 connector
151