Installing The Control Board Cb2-Ptx; Figure 268: Removing A Control Board - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide

Installing the Control Board CB2-PTX

420

Figure 268: Removing a Control Board

To install a Control Board (see
Attach an ESD grounding strap to your bare wrist, and connect the strap to an approved
1.
site ESD grounding point.
Carefully align the bottom and then the top edges of the Control Board with the guides
2.
inside the chassis.
Slide the Control Board into the chassis, carefully ensuring that it is correctly aligned.
3.
Twist both ejector handles clockwise to seat the host subsystem until the ejectors
4.
latch into the faceplate.
NOTE: While installing, ensure that you install the Control Board that is
compatible with the Routing Engine. Install the Routing Engine
RE-DUO-C2600-16G into the Control Board CB-PTX and Routing Engine
RE-PTX-X8-64G into the Control Board CB2-PTX only.
Figure 269 on page 421):
Copyright © 2017, Juniper Networks, Inc.