Figure 220: Installing A High Capacity Delta Ac Pdu - Juniper PTX5000 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.

Figure 220: Installing a High Capacity Delta AC PDU

Using both hands, slide the PDU into the chassis until you feel resistance.
4.
Push the front installation handle up toward the PDU, and secure the handle with the
5.
captive screws.
Using a number 2 Phillips (+) screwdriver, loosen the four captive screws that secure
6.
the metal retaining bracket to the newly installed PDU. Remove the metal retaining
bracket from the PDU.
Using a number 2 Phillips (+) screwdriver, loosen the two captive screws on the metal
7.
AC wiring compartment of the replacement PDU. Open the metal door of the metal
AC wiring compartment.
Gently push the wires of the AC power cord into the area for the metal retaining bracket,
8.
and pull the wires to the left toward the metal AC wiring compartment.
Using a number 2 Phillips (+) screwdriver, use the four captive screws on the metal
9.
retaining bracket to secure the AC power cord to the PDU. See
Chapter 27: Removing and Installing Power System Components
Figure 221 on page 348.
347