Removing A Ptx5000 Pic Cable; Installing A Ptx5000 Pic Cable - Juniper PTX5000 Hardware Manual

Removing a PTX5000 PIC Cable

Installing a PTX5000 PIC Cable

Copyright © 2017, Juniper Networks, Inc.
Removing and installing PIC cables does not affect packet transport router function,
except that a PIC does not receive or transmit data while its cable is disconnected. To
remove a PIC cable:
Have ready a rubber safety cap for each fiber-optic cable and fiber-optic transceiver.
1.
If removing all cables connected to the PIC, use one of the following methods to take
2.
the PIC offline:
Press its online/offline button.
Issue the following CLI command:
user@host> request chassis pic fpc-slot fpc-slot pic-slot pic-slot offline
Unplug the cable from the cable connector port. Immediately cover each fiber-optic
3.
transceiver and the end of each fiber-optic cable with a rubber safety cap.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing cable. The safety cap keeps the port clean and
prevents accidental exposure to laser light.
Remove the cable from the cable management system and detach it from the
4.
destination port.
To install a PIC cable (see
Have ready a length of the type of cable used by the PIC. For cable specifications, see
1.
the PTX Series Interface Module Reference.
Remove the rubber safety plug from the PIC cable connector port.
2.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
Chapter 32: Removing and Installing Interface Module Components
Figure 276 on page 441):
439