Juniper PTX5000 Hardware Manual page 470

PTX5000 Packet Transport Router Hardware Guide
434
Insert the appropriate cable into the cable connector ports on each PIC on the FPC.
17.
Secure the cables so that they are not supporting their own weight. Place excess cable
out of the way in a neatly coiled loop, using the cable management system. Placing
fasteners on a loop helps to maintain its shape.
CAUTION: Do not let fiber-optic cable hang free from the connector. Do
not allow fastened loops of cable to dangle, which stresses the cable at
the fastening point.
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
Use one of the following methods to bring the FPC online:
18.
Press and hold the FPC online/offline button until the green
button lights steadily, in about 5 seconds.
Issue the following CLI command:
user@host>request chassis fpc slot slot-number online
CAUTION: After the
removing the FPC again, removing an FPC from a different slot, or inserting
an FPC in a different slot.
You can also verify correct FPC and PIC functioning by issuing the
show chassis fpc pic-status
on page 485.
LED lights steadily, wait at least 30 seconds before
OK
commands, as described in
LED next to the
OK
show chassis fpc
"Maintaining the PTX5000 FPCs"
Copyright © 2017, Juniper Networks, Inc.
and