Figure 46: High Capacity Dc Psm Leds; Table 28: High Capacity Dc Power Supply Module Leds - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide

Table 28: High Capacity DC Power Supply Module LEDs

LED Color
Input 1 OK Green
–
Input 2 OK Green
–
Output OK Green
–
Red
Fault ( )
–
70

Figure 46: High Capacity DC PSM LEDs

1 2 3
1— 1 OK
Input LED
2— 2 OK
Input LED
State
On steadily
Blinking
Off
On steadily
Blinking
Off
On steadily
Blinking
Off
On steadily
Off
4
3—
Output
4—
Fault (
Description
Input 1 is present, the PSM is receiving voltage between –40 V and
–72 V.
PSM is receiving voltage outside –40 V and –72 V.
Input voltage is not present on input 1.
Input 2 is present, the PSM is receiving voltage between –40 V and
–72 V.
PSM is receiving voltage outside –40 V and –72 V.
Input voltage is not present on input 2.
Power supply output is functioning normally.
PSM is not enabled or is in a fault condition, or the input voltage
to the PSM is too low.
Output is not functioning normally because of a fault condition or
the PSM is not receiving input voltage.
PSM might be starting up, not properly installed, not receiving
sufficient power, or not functioning properly.
No faults have been detected for the PSM, or the PSM is not
receiving any input voltage.
OK
LED
) LED
Copyright © 2017, Juniper Networks, Inc.