Installing The Front Door On The Router; Rack - Juniper PTX5000 Hardware Manual

CHAPTER 18

Installing the Front Door on the Router

Installing the Front Door on a PTX5000 Packet Transport Router in a Four-Post Rack
Copyright © 2017, Juniper Networks, Inc.
Installing the Front Door on a PTX5000 Packet Transport Router in a Four-Post
Rack on page 179
Installing the Front Door on a PTX5000 Packet Transport Router in an Open-Frame
Rack on page 181
Optionally, you can install a door over the front card cage of the PTX5000. Captive
thumbscrews secure the door in a closed position.
CAUTION: You can Install the front door any time after you have installed
the chassis into the rack and grounded the router. Perform the procedures
described in"Installing the PTX5000 Mounting Hardware for a Four-Post
Rack or Cabinet" on page
Lift" on page 174, and
before proceeding.
Before you begin, ensure that you have the following parts and tools available to install
the front door on a PTX5000 in a four-post rack.
Electrostatic discharge (ESD) grounding strap
Phillips (+) screwdriver, number 2
To install the front door on a PTX5000 in a four-post rack (see
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
1.
connect the strap to the approved ESD site grounding point.
Partially loosen the mounting screws that secure the chassis to the front of the
2.
four-post rack, beginning with the fourth hole from the top of the chassis, ending with
the seventh hole from the top of the chassis. Do this for both front-mounting flanges.
When you are done, there should be four screws loosened on each side of the chassis.
165, "Installing the PTX5000 By Using a Mechanical
"Connecting the PTX5000 Grounding Cable" on page 185
Figure 85 on page 181):
179