Table of Contents
Advertisement
HANDHELD-PROGRAMMER OPERATING
D-1
DESCRIPTION
The Handheld Programmer (hereinafter referred to as the Programmer) provides the system
installer/service person with a convenient means to assign device address information and test
device operation.
D-2
GENERAL NOTE
Prior to using the Programmer, you need to ensure that you have the supplied accessories, listed
in the table below:
D-2.1
Accessory List
Part No.
74-200013-001
06-117999-001
06-118003-001
06-117998-001
* All supplied in top level Part No. 74-200013-001
D-3
DEVICES SUPPORTED
The Programmer is designed to support all SmartOne intelligent/addressable devices. A table of
supported devices accompanies these instructions.
Prepare the Programmer for Operation with AC Adapter
1. Connect Device Interface Cable to the SLC connector on the top of the Programmer.
2. Connect the small plug of the power pack to the DC IN connector on the top of the
Programmer, and then plug the line cord into a 120 Vac, 60Hz outlet.
3. Verify that the green "DC Input" LED is lit. The yellow "Bat. Charger" LED will also light if
the batteries are not fully charged.
4. Set the power switch to the "on" position (up direction).
5. Verify that the green "Power On" LED is lit and that the display is flashing each of the
segments used to display characters.
6. After 30 seconds ensure the top row of the display is flashing (---). The bottom row of the
display should be blank.
P/N 06-236530-001
Handheld-Programmer Operating Instructions
APPENDIX D
INSTRUCTIONS
Description
Device Programmer (complete Unit)
AC/DC Power Pack*
AC Cord*
Battery Pack (installed in device)*
D-1
August 2013
Advertisement
Table of Contents
