Table of Contents
Advertisement
Step
1
Press 0 Key
2
Enter Password; Press "Enter" Key
3
Press 3 Key
4
Press 3 Key
5
Press 2 Key
6
Press 2 Key
7
Press 1 Key
8
Press 1 Key for Fixed or Press 2 Key for Day/Night
Settings.
9
Use keypad to enter single detector or range of
detectors to change pre-alarm/alarm thresholds.
Press "Enter" Key to confirm selection
10
Press 1 Key for Open Area or
Press 2 Key for In-duct or
Press 3 Key for DH-2000
Press "Enter" Key to confirm selection.
11
Use keypad to enter pre-alarm threshold.
Press "Enter" Key to confirm selection.
12
Use keypad to enter alarm threshold.
Press "Enter" Key to confirm selection.
12A
Use keypad to enter night alarm threshold.
Press "Enter" Key to confirm selection.
13
Wait until "Updated Thresholds for Device x"
message disappears from the display.
14
Press "Backspace" Key (as required)
P/N 06-236530-001
Action
3-39
Result
Initiate menu access
Gain access to menus
Enter Set-Menu branch
Access "SLC Devices" option
Select "Configuration"
Select Photoelectric Detectors
Select alarm thresholds
Select fixed (i.e., not variable) thresholds or
select day/night (i.e. variable by time of day)
thresholds
Specify detectors to change
Specify detector application
Set pre-alarm threshold
Set alarm threshold. This is the day alarm
threshold when using day/night settings.
Set night alarm threshold (day/night only)
Exit Menu System
August 2013
Advertisement
Table of Contents
