Table of Contents
Advertisement
3-3.15
Remote Alarm Events
Remote alarm events from a networked control unit are shown in the upper line of the
LCD display by:
•
•
•
•
The lower line indicates the up-to-40-character message assigned to the alarm-initiating
device using the ARIES configuration program.
The following actions also occur when the control unit is configured as Group 0 or when
the alarm event is either from another control unit in the same group as the control unit
or from any other control unit in a network configured for global operation.
1. The Alarm LED on the display flashes
2. The internal buzzer sounds continuously
3. The alarm event is stored in the event log
4. The alarm message is transmitted to peripheral devices such as RDCMs and ATM-
5. The alarm message is communicated via the NIC and RS-232 ports, as applicable
6. Point- or group-specific and general-alarm outputs activate, including previously-
Refer to Paragraph 3-2.5.4.1 for what to do when a remote alarm message is received.
3-3.16
Remote Positive-Alarm-Sequence (PAS) Events
Remote PAS events from a networked control unit are shown in the upper line of the LCD
display by:
•
•
•
•
The lower line indicates the up-to-40-character message assigned to the alarm-initiating
device using the ARIES configuration program.
P/N 06-236530-001
Node-of-origin
Device address
Change of state
Device type
Node Number
N:02
010 ALARM
COMPUTER ROOM
Device-Specific
Custom Message
Figure 3-62. Typical Remote Alarm Message Display
Ls, if applicable
silenced outputs.
Node-of-origin
Device address
Change of state
Device type
Device Address 010
Alarm Indication
Device Type
Reporting Alarm
ON
MANUAL STATION
3-131
August 2013
Advertisement
Table of Contents
