Table of Contents
Advertisement
3-2.5.2.4.17 How to Enable the Flashing LEDs on SmartOne Detectors
Step
1
Press 0 Key
2
Enter Password; Press "Enter" Key
3
Press 3 Key
4
Press 3 Key
5
Press "Scroll" Key
6
Press 5 Key
7
Use keypad to select address or range of
addresses to re-enable detector-LED flashing.
Press "Enter" Key to confirm selection.
8
Press 2 Key and then press "Enter" Key to confirm
selection.
9
Wait until the message appears in the display,
completed or failed.
10
Exit Menu System
3-2.5.2.4.18 How to Replace an SLC Device
Step
1
Press 0 Key
2
Enter Password; Press "Enter" Key
3
Press 3 Key
4
Press 3 Key
5
Press "Scroll" Key
6
Press 6 Key
7
Enter the address of the device being replaced
and then press "Enter" Key to confirm selection.
8
Enter the address of the new device being added
and then press "Enter" Key to confirm selection.
9
Press 1 key to keep the current settings for the
new device or press 2 key to use the default
settings.
10
Exit Menu System
P/N 06-236530-001
Purpose: To enable one or more SmartOne detector LEDs to resume
flashing in standby operation. The flashing LEDs were disabled in a
prior blink-control operation.
Action
Purpose:
To replace an existing device on an SLC with a new device.
Note: Before performing the following procedure, remove the "old"
device and connect the "new" device to the SLC. The "old"
device must report as "trouble open" and the "new" device must
report as "unregistered" to ensure that the devices have
different addresses.
Action
3-47
Result
Initiate menu access
Gain access to menus
Enter Set-Menu branch
Access "SLC Devices" option
Access additional options
Select "Blink Control"
Specify addresses to enable flashing LEDs in
normal operation
Re-enable flashing LEDs
Number of detectors are shown.
Result
Initiate menu access
Gain access to menus
Enter Set-Menu branch
Access "SLC Devices" option
Access additional options
Select "Replace Device"
Specify "Address to be Replaced (1-255)"
Specify "Address of Replacement Device
(0-255)"
Select "Use Existing" or "Set Default" for the
settings of the new device.
August 2013
Advertisement
Table of Contents
