Kidde ARIES Installation, Operation And Maintenance Manual page 156

3-2.5.2.4.55 How to Isolate a Networked Control Unit
Step
1 Press 0 Key
2 Enter Password
3 Press 3 Key
4 Press "Scroll" Key
5 Press 6 Key
6 Press "Scroll" Key twice
7 Press 9 Key
8 Press 1 Key and then press "Enter" Key to confirm
selection.
9 Press "Backspace" Key (as required)
10 Press "Acknowledge" Key
3-2.5.2.4.56 How to De-Isolate a Networked Control Unit
Step
1 Press 0 Key
2 Enter Password
3 Press 3 Key
4 Press "Scroll" Key
5 Press 6 Key
6 Press "Scroll" Key twice
7 Press 9 Key
8 Press 2 Key and then press "Enter" Key to confirm
selection.
9 Press "Backspace" Key (as required)
August 2013
Purpose: To prevent a networked control unit from broadcasting event
messages and control commands to other networked control units and
to prevent the control unit from processing and acting upon event
messages and control commands broadcast from other networked
control units.
A Supervisory signal will occur after each Isolation command is
executed, and will remain in effect until all Isolation commands are
subsequently
commands.
Action
Purpose: To enable a networked control unit to broadcast event
messages and control commands to other networked control units and
to enable the control unit to process and act upon event messages and
control commands broadcast from other networked control units.
Action
3-74
cancelled by their
Initiate menu access
Gain access to menus
Enter Set-Menu branch
Access additional options
Select "Network" option
Access additional options
Select "Isolate/De-Isolate Node"
Select "Isolate"
Exit Menu System
Silence buzzer and change Supervisory LED from
flashing to steady
Initiate menu access
Gain access to menus
Enter Set-Menu branch
Access additional options
Select "Network" option
Access additional options
Select "Isolate/De-Isolate Node"
Select "De-Isolate"
Exit Menu System
corresponding De-Isolation
Result
Result
P/N 06-236530-001