Remote Supervisory Events - Kidde ARIES Installation, Operation And Maintenance Manual

Fire alarm/suppression
Table of Contents

Advertisement

The following actions also occur when a control unit is configured as Group 0 or when the
alarm-verification event is either from another control unit in the same group as the
control unit or from any other control unit in a network configured for global operation.
1. The internal buzzer pulses
2. The alarm-verification event is stored in the event log
3. The alarm-verification message is transmitted to peripheral devices such as RDCMs,
4. The alarm-verification message is communicated via the NIC and RS-232 ports, as
Refer to Paragraph 3-2.5.5.4 for what to do when a remote alarm-verification message
is received.
Note: The time remaining on the alarm-verification timer will only appear on the display
3-3.18

Remote Supervisory Events

Remote supervisory events from a networked control unit are shown in the upper line of
the LCD display by:
The lower line indicates the up-to-40-character message assigned to the device using the
ARIES configuration program.
The following actions also occur when the control unit is configured as Group 0 or when
the supervisory event is either from another control unit in the same group as the control
unit or from any other control unit in a network configured for global operation.
1. The Supervisory LED on the display flashes
2. The internal buzzer pulses
3. The supervisory event is stored in the event log
4. The supervisory message is transmitted to peripheral devices such as RDCMs and
5. The supervisory message is communicated via the NIC and RS-232 ports, as
6. Point- or group-specific and general-supervisory outputs activate, including
Refer to Paragraph 3-2.5.6.1 for what to do when a remote supervisory message is
received.
P/N 06-236530-001
if applicable
applicable
of the control unit that received the verification report from the smoke detector.
Remote, networked control units will not display the alarm-verification timer.
Node-of-origin
Device address
State change
Device type
Node Number
N:02
070 SUPERVISORY ON
FIFTH-FLOOR GATE VALVE
Device-Specific
Custom Message
Figure 3-65. Typical Remote Supervisory Message Display
ATM-Ls, if applicable
applicable
previously-silenced outputs.
Device Address 070
Supervisory On
Indication
MONITOR MODULE
3-133
Device Type
August 2013

Advertisement

Table of Contents
loading

Table of Contents